5 Nm3/H PEM Electrolyzer Stack

PEM electrolyzer The single-layer structure of the PEM electrolytic cell stack is: cathode plate, cathode sealing frame, cathode cavity, cathode current collector layer, membrane electrode, anode current collector layer, anode cavity, anode sealing frame, anode plate, between each single layer A titanium plate is isolated, and finally the anode and the anode are provided with titanium end plates reserved for gas, water channels, and positive and negative terminals. The structural design, material selection, and assembly process of the electrolytic cell stack are very important, and are directly related to the overall performance of the hydrogen production ratio. The electrolytic cell stack produced by our company has high current density, low electrolysis voltage, and low hydrogen leakage rate. The advantages of high pressure resistance and long life .

Preparation The electrolyzer should be stored in a non-freezing area. The installed electrolyzer is filled with water, and the input and output ports are in a protective closed state. The electrolytic cell is tightly packed before leaving the factory. When unpacking, please follow the signs on the wooden box to avoid tilting or inverting. Remove the fixing bolts that fix the electrolytic cell on the packing box, place the electrolytic cell on the chassis of the hydrogen generator and fix it with the bottom corner. Remove the red gasket at the hydrogen interface (protection during transportation), and remove the hose connected to the water inlet and outlet ,